4/6/2024 0 Comments Midway 1292 tumbler parts![]() The silicone is there to protect the foam pad from any sharp edges that may tear it during operation. With the foam pad removed you will notice that each nut and bolt is coated and surrounded with clear silicone. Remove silicone from around the nuts and bolts If you damage the foam and cannot reuse it you can purchase a new one on our UV-10 parts page. Removing the foam pad will give you access to the four nuts on the motor studs and the two flat head bolts that secure the motor brackets. To remove it just pull lightly and work it off slowly. The pad is stuck to the top with a sticky backing. Remove the foam carefully so you can reuse it after replacing the motor. The foam pad, on the vibrator plate where the barrel sets, needs to be removed. This will take some effort and may require using the vice grips to grip the strain relief bushing on the back side of the vibrator plate. Pull the motor wire and strain relief bushing out of the slot on the vibrator plate of the tumbler. The black on the vibratory plate is the foam pad that needs removed. In this image you can clearly see the strain relief bushing and the slot in the vibrator plate it was in. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |